GeoTesting Express is a provider of Geosynthetic Testing Services – ASTM D,Test Method for Determining the (In-plane) Flow Rate per Unit Width and . ASTM D Test Method Determining the (in-plane) Flow Rate Per Unit Width and Hydraulic Transmissivity of a Geosynthetic Using a Constant Head. Last previous edition approved in as D – 2. For referenced ASTM standards, visit the ASTM website, , or contact ASTM Customer.

Author: Tek Sakazahn
Country: Sao Tome and Principe
Language: English (Spanish)
Genre: Business
Published (Last): 14 November 2018
Pages: 15
PDF File Size: 2.50 Mb
ePub File Size: 18.99 Mb
ISBN: 785-2-70198-342-5
Downloads: 3164
Price: Free* [*Free Regsitration Required]
Uploader: Kagakinos

Please reply me within 24 hours. Combining values from the two systems may result in non-conformance with the standard. The average results from the two laboratories should be compared using the Student’s t -test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun.

Send your message to this supplier. I would like your verified suppliers matching service! Link to Active This link will always route to the current Active version of the standard.

Please reply me widthin 24 hours. Recommended Quality Verified Suppliers.

Inquiry Sent Successfully Confirmation email has been sent: Your message has been sent to the following suppliers. Pressure Pump and Testing Cylinder Easy to operate, the result more accurate. Please enter 20 to characters to contact this supplier! The flow of water within the plane of a geotextile or geotextile-related aatm is measured under varying normal compressive stresses, with typical x4716 gradients and with defined contact surfaces.


Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product.

Products – BT Technology

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Competent statistical assistance is recommended for the investigation of bias. Application Geotextile Water Flow Capacity Tester, to determing the constant-head water flow capacity within the plane of a geotextile or geotextile-related product.

Your email address is incorrect! Comparative tests as directed in 5.


It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Enter your email please. Features Diaphragmpressurizing High pressure, Keeping pressure long time, easy to maintain, can greatly reduce the testing cost.

Your message must be betweencharacters! If bias is found, either its cause must be found and corrected or the purchaser and supplier must agree to interpret future test results in light of the known bias.


Historical Version s – view previous versions of standard. Site Member 3 Years. For the best results, we recommend including the following details: As a minimum, the two parties should take a group of test specimens that are as homogenous as possible and that asmt formed from a lot of the material of the type in question. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing.

ASTM D4716 Geosynthetic in-Plane Water Flow Rate Tester

Forward Filter Manufacturers Co. The test is intended primarily as an index test but can be used also as a performance test when the hydraulic gradients and specimen contact surfaces are selected by the user to model anticipated field conditions.

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other.